The Reconditioned Kenwood Chef By Kenmix Engineering
  The Reconditioned Kenwood Chef             By Kenmix Engineering

Price List 

Full Restoration

£539.00 Any variance of Kenwood Chef a700 (a700a edition 1 & 2, a700b and a700d

 

£329.00 Any variance of Kenwood Chef a701 and a701a

 

£349.00 Any variance of Kenwood Chef a901, a902/904, KM200 series, KM300 series and KM400 and KM500

 

£549.00 any variance of Kenwood Major a706a, 706b and 706d

 

£349.00 any variance of Kenwood Major a707a, a717b, a717c, a907, KM230, KM250, KM600 series  and KM800 series

 

£339.00 any variance of Kenwood Chef Titanium KM001, 002, 003, 005

 

£349.00 any variance of Kenwood Major Titanium KM010 and KM020. Not available for KM030 or later

 

A full restoration includes the following:-

 

Complete strip down, thorough wash, clean and degrease of all appliance body parts and plastic trims

Glass beading of metal body parts to remove all paint and erosion where appliacable and preparation for respray. " coats of primer and 2 coats of gloss top coat enamel

Rub down of plastic parts and preparation for respray. 2 coats of primer, 2 coats of top coat enamel.

All fasteners and other parts, ie, hinge pin, latch assembly etc to be soaked in a cleaner and then polished. Even the parts that are not visible.

Complete dismantle, clean, reassembly of motor to include motor brushes if needed, motor components as standard. The a700 models will be fitted with a new purpose built circuit board.

Split and clean gearbox and gears, check gearing, reassemble, regrease and test.

New power lead and 5amp plug, new feet, gearbox barrier felt

 

There may be a charge for missing parts, should replacement be required. This applies to worn parts if they cannot be repaired.

 

5 year documented warranty as from 1 April 2025 to replace the existing 3 year warranty and 1 year electrical safety test. The warranty covers all labour time required to reinstate any appliance that fails performance and in the unlikely event that it needs to be recalled. The warranty does not include broken parts

 

Average restoration time 16 - 28 hours depending on model

 

Full Service to all models of Kenwood Chef Listed Below

 

£209.00 All model variances of Kenwood Chef 701, 901, 902/904, KM200, 201, 210, 300, 400 and other KM models to include Titanium KM001, 003 and 005.

 

£329.00 All Models of Kenwood Chef a700 (a700a edition 1 & 2, a700b and a700d

 

£339.00 Major 706a, 706b and 706d

 

£209.00 All model variances of Kenwood Major 707, 717, 907, KM230, 250, 280, 600, 800 and other KM Models to include Major Titanium Km010 and 020.

 

Service of KM030,KMM or KMC030, KVL models, KVC models, Kmix, Prospero, Patisserie or any model with digital display not available.

 

A Full Service includes the following.

Complete strip, degrease, wash and clean. Gearbox grease replacement or top up, gearbox seal replaced if required. All motor components as standard and motor brushes if required. New power lead and plug with 5 amp fuse. Gearbox barrier felts and base feet.

Does not include broken of missing parts

 

3 year documented warranty and 1 year electrical safety test. The warranty covers all labour time required to reinstate any appliance that fails performance and in the unlikely event that it needs to be recalled. The warranty does not include broken parts

 

Approximate service time 8 - 14 hours depending on model

 

Shipping and Packaging Standard £150.00 Compensation

Collection UK 48hr £16.60- Highlands and Islands, Isle ofWight, EU and other destinations, please ask for quote.

Redelivery UK 48hr including packaging £26.58. Highlands and Islands 48hr, Isle of Wight 24hr and EU and Channel Islands 48hr POA. (Subject to courier changes) Other destinations, please ask for quote

Potential parts

 

£15.99 Set of 4 neoprene motor mounts - a701, a701a, a707a, a717b, a717c - Usually when the motor has dropped out or the mounts are brittle.

£14.99 Replacement gearbox pulley bush kit including repair - 701, 707, 717, 901, 902, 907, KM200, 230, 250, 500 - Usually when the rubber anti vibration bushes have deteriorated / includes labour

£9.45 Re-machining of worn or squared off latch pin - all models - Usually when the appliance will not latch down.

£ 12.99 Broken motor speed control cam - a701, a701a, a707a, a717b, a717c

POA Broken motor speed control cam - a700a, a700b, a706a, a706b

£42.00 Repair broken motor casing a700d, any section - All the broken pieces need to be available.

£19.85 Broken motor circuit cover - a700d - Price as per supplier price at the time of order.

POA Motor armature - Usually a701, a701a - a707a, a717b, a717c - Usually when the appliance is running slow, crackling and throwing orange sparks from the commutator or sometimes when the motor is dead - depends on availability

POA Motor armature - Usually a700a, rarely a700b, a700d - Usually when the appliance is running slow, crackling and throwing orange sparks from the commutator or sometimes when the motor is dead - depends on availability and the delay on sourcing this part could be lengthy

£35.00 Field coil rewire- a700a, a700b, a700d, early a701 models 1960 - 1967 - The field coil wire was sheathed in rubber on the early models and therefore the sheathing can become stiff, brittle or cracked due to motor heat. these wires will be removed and replacement pvc coated will be fitted.

POA Broken pinion gear

POA Broken gearbox base housing

 

Shipping costs apply as advised in the servicing section above and could be subject to change due to any increase in courier or packaging costs

Attachment Restorations as follows

£43.99 Cream maker. To include paint strip and respray in white gloss and cleaning and re-assembly of all parts

 

£46.99 a720 / a920 mincer to include paint strip and respray in silver and cleaning and re-assemblyu of all parts

 

£19.99 Liquidiser base service to include full strip, clean and polish of all parts, lubrication and new base gasket

 

£29.00 Stainless steel bowl polishing

 

£7.95 Tools cleaning and polishing per piece

 

£43.00 Colander and sieve

 

Coffee grinder

£79.00 a700

£45.00 a701 ; a901

 

Other attachments, please ask as not all are able to be restored

On  Site Repairs

Local all PO and SO postcodes. Can include other postcodes by prior appointment

Other Repairs

Motor Reconditioning

 

£195.00 - a700a, 700b Motor repair which includes complete strip down and thorough casing clean, wire replacement / resheath where applicable, cleaning of field coil and armature, new motor components and brushes, (the a and b models will be fitted with a new circuit board) new power lead and separate 5 amp fused plug in white. Motor cowling riveted and security sealed. 3 year warranty

 

£185.00 - a700d Motor repair includes complete strip down and thorough casing clean, wire resheath, cleaning of field coil and armature, new motor components and brushes, new power lead and separate 5 amp fused plug, both in black or white.  Motor security sealed. 3 year warranty

 

£88.99 Motor reconditioning to all other Chef models. This includes complete strip down, thorough inside casing clean, wire resheath if required, cleaning of field coil and armature, new components. Does not include KM post 2001 and Titanium models. Price on application for these as the motor may need to be replaced. 1 year warranty.

 

Speed control module repair should the module be overwound past pulse £35.00

1 year warranty

 

Gearbox Repairs and Rebuild

£82.99 - All models of Kenwood Chef and Major Food Mixers a701 - a717 including, split and dismantle, degrease, clean thoroughly, reseal, reassemble, regrease, new belt drive bushes if worn. Does not include replacement gears or planetary hub. Does include pulley repair and/or clutch dog

3 year warranty.

 

Price for the above with a replacement pinion gear £98.99

 

£78.99 All models of 901 and KM Chef and Major with no exclusions other than the KMix and Prospero. Including, split and dismantle, degrease, clean thoroughly, reseal, reassemble, regrease and replacement belt pulley bushes if required. Does not include replacement gears or planetary hub. Includes 3 year warranty. 

 

£81.99 Titanium Chef and Major Gearboxes including a 3 year warranty. Does not include replacement gears or other parts. This may become a limited service due to availability of spare parts as spare parts for these have been discontinued.

 

Business Hours

Kenmix Engineering

Unit A100 The Sanderson Centre

Lees Lane

Gosport

Hampshire

PO12 3UL

 

07720 647321

kenmixengineering@hotmail.co.uk

Monday - Friday

Workshop 9.30am - 5.30pm

Satuday

Workshop 11am - 5pm

Customer deliveries

11am - 4pm Monday - Saturday by appointment only

 

EMAIL AND TELEPHONE ENQUIRIES RECEIVED OUT OF THESE HOURS MAY NOT BE ANSWERED UNTIL THE NEXT WORKING DAY.

All text content of this website has been created by Kenmix Engineering and all photographic content is of work carried out by Kenmix Engineering. Under no circumstances will Kenmix Engineering authorise use of any of this content on any other website or advertising structure, unless otherwise agreed.

 Kenmix Engineering is a Sole Trader Company and is not associated with any other Restoration organisation.

Website Copyright Kenmix Engineering 2011

Infringement will result in legal action

Print | Sitemap
© kenmixengineering